11/30/2023 0 Comments Harbor freight channel locksMy HFT demo hammer-drill did all the holes in probably 30 minutes, perfectly. DeWalt cordless tools were useless, he couldn't drill even one hole full-depth, and when I saw him start hammering-in those expensive HILTI threaded anchors into partially-drilled concrete holes, where the anchors 'set' well-before the threads came-close to the PT boards, I fired him on the spot. The telephone number for the Harbor Freight store in Tullahoma (Store 495) is 1-93. Mondays through Saturdays, and from 9 a.m. I was using a sub-contractor recommended by the building supplier (a 10' X 20' Hardi-Board sided standing seam seal roof, roll-up OH door building) and his P.O.S. The Harbor Freight Tools store in Tullahoma (Store 495) is located at 1600 N Jackson St Ste 320, Tullahoma, TN 37388. I was sinking 5/8" threaded HILTI anchors to fasten a PT footer-board to a recent concrete pour. It cost me > 1/2 the price I paid for my HFT demo hammer-drill. I did buy a Bosch SDS-MAX bit as a back-up, but so-far, I haven't had to put it to-use. I bought a Harbor Freight demo hammer-drill in SDS-MAX size, 8-1/2 amps, which has saved me thousands of dollars on demo work and new construction, and their bits in SDS-MAX have likewise held-up. I have a Chicago Electric orange-body side-grinder, I use either 4" or 4-1/2" cut-off wheels/grinding wheels, and while I've had-to finally make a kludge-fix to them after a carbon brush button came-adrift, they're still doing duty with no issues. The hand and electric tools I've bought from HFT have always done what I needed to-do, and I am not disappointed in their longevity. All of them are good-performing, the finish is holding-up, and they sit in south Florida heat and humidity, un-air-conditioned, so a bit of surface rust is going to happen. It may not be the easy way, but that’s what it takes to make ‘em legendary. Forged in Meadville, P.A., every pair of our CHANNELLOCK pliers is built to do more than just finish the jobthey’ll flat out conquer it. river and harbor act of July 25, 1912 to dredging and snagging in the channel. That’s why we’ve been making hardworking pliers and assorted hand tools for hardworking tradespeople since 1886. You can see below the water pump slip-joint pliers, a pair of double-jointed needle-nose pliers in straight and curved configurations. Although the locks in the Yamhill River are little used, these locks. I pick & choose HFT purchases, and I have a pair of the large water pump pliers as-well as other Doyle brand pliers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |